Trail-master 4.0 Inch Lift Kit with NGS Shocks (TM3340-40013 w/ Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Trail-master 4.0 Inch Lift Kit with NGS Shocks (TM3340-40013 w/. Trail Master 4.0 Inch Lift Kit with NGS Shocks (TM3340-40013 w/ Nitro Shocks) User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
1
WARNING
Many states and municipalities have laws restricting
bumper heights and vehicle lifts. Consult state and
local laws to determine if the changes you intend to
make to the vehicle comply with the law.
WARNING
The installation of larger tires may reduce the effec-
tiveness of the braking system.
WARNING
Always wear eye protection when operating power
tools.
WARNING
Before you install this kit, block the vehicle tires to
prevent the vehicle from rolling.
WARNING
DO NOT combine suspension, body, or other lift de-
vices. Use of vehicle with combined lifts may result
in unsafe and/or unexpected handling characteris-
tics.
NOTE
Lift height may vary depending on vehicle configura-
tion, engine size, additional accessories, the factory
suspension package, and vehicle’s condition.
NOTE
Trail Master recommends using thread locking com-
pound on the threads of all kit nuts and bolts unless
specified otherwise in these instructions.
WARNING
Installation of a Trail Master suspension lift kit will
change the vehicle’s center of gravity and handling
characteristics both on- and off-road. You must drive
the vehicle safely! Extreme care must be taken to
prevent vehicle rollover or loss of control, which
could result in serious injury or death. Avoid sudden
sharp turns or abrupt maneuvers and always make
sure all vehicle occupants have their seat belts fas-
tened.
WARNING
Before you install this kit, read and understand all
instructions, warnings, cautions, and notes in this
instruction sheet and in the vehicle owner’s manual.
CAUTION
Proper installation of this kit requires knowledge of
the factory recommended procedures for removal
and installation of original equipment components.
We recommend that the factory shop manual and
any special tools needed to service your vehicle be
on hand during the installation. Installation of this kit
without proper knowledge of the factory recom-
mended procedures may affect the performance of
these components and the safety of the vehicle. We
strongly recommend that a certified mechanic famil-
iar with the installation of similar components install
this kit.
WARNING
This kit should only be installed on a vehicle that is in
good working condition. Before you install the kit,
thoroughly inspect the vehicle for corrosion or defor-
mation of the sheet metal. If the vehicle is suspected
to have been in a collision or misused, do not install
this kit. Off-road use of your vehicle with this kit in-
stalled may increase the stress applied to the factory
components. Failure to observe this warning may
result in serious personal injury and/or severe dam-
age to your vehicle.
400 W. Artesia Blvd. Fax: (310) 747-3912
Compton, CA 90220 Ph: (877) 695-7812
www.trailmastersuspension.com
JEEP WRANGLER 4 DOOR (JK) 4” SPRING KIT
‘07- ’13 KIT# TM3340-40013 w/ Nitro Shocks
Vue de la page 0
1 2 3 4 5 6 ... 11 12

Résumé du contenu

Page 1

1 WARNING Many states and municipalities have laws restricting bumper heights and vehicle lifts. Consult state and local laws to determine if the cha

Page 2

10 Kit Parts List: TM3340-40013 Kit: 2 4” Coil Spring (TM3340-60020, front) 2 4” Coil Spring (TM3340-60030, rear) 2 Absorber (shock, front, TM732650

Page 3

11 Revision Page:

Page 4 - Install Front Suspension

12 Notice to Owner Operator, Dealer and Installer: Vehicles that have been enhanced for off-road performance often have unique handling characteristic

Page 6 - Prepare to Install Rear

3 Before Starting Installation 1. Carefully read all warnings and instructions com-pletely before beginning. 2. Verify all parts have been received in

Page 7 - Install Rear Suspension

4 Prepare to Install Front Suspension 1. Loosen, but do not remove, lug nuts on each front wheel. 2. Jack the rear of the vehicle with the floor jac

Page 8

5 3. Install the front track bar relocation bracket (82-TM20032) into the original track bar mounting pocket using the OE bolt and supplied spacer (3

Page 9 - Dynamic Vehicle Check

6 18. 2011-2013 models only: Install the front brake line brackets (35-TM20030 drvr and 35-TM20031 pass) to the front spring pads and se-cure using th

Page 10 - Kit Parts List:

7 Install Rear Suspension 1. Install the track bar drop bracket (82-TM20038) into the track bar mounting position using the previously removed 9/16”

Page 11 - Revision Page:

8 8. Install the rear brake line drop (35-TM20010) to the OE hole in the frame using the previously removed OE hardware. 9. Reconnect the rear brake

Page 12

9 After Completing Installation Engine Compartment 1. Connect both battery cables. Connect positive cable first, then negative cable. Miscellaneous

Commentaires sur ces manuels

Pas de commentaire